Pwosesis la obligatwa ultrafine pulverizer
Apr 10, 2023
Nan dè milye nou nan ane nan istwa istwa, nou te te lè l sèvi avèk Tradisyonèl Chinwa trete maladi nou nou country, sosyal syans ak teknoloji , nou gen piti piti reyalize ke si si tradisyonèl Chinwa Medsin trete selon anvan metòd metòd, li pa pral reyalize efè a nou espere!
The ultrafine pulverizer adopts medium temperature, low temperature and ultra-low temperature pulverization, which is more superior to dense shellfish, bone medicinal materials and mineral medicinal materials, and is suitable for materials with fibrous, high toughness or certain moisture content. Therefore, the scope of application wider. After the medicinal materials are micronized, because the dissolution rate of the active ingredients is improved, the curative effect of the original prescription can be obtained or the curative effect is better with a dose smaller than that of the original prescription. After ultrasonic extraction, the content of geniposide and berberine in the ultrafine powder of Huanglian Jiedu Powder increased by 26.26 percent and 37.07 percent , respectively, compared with the fine powder. According to statistics, depending on the nature of medicinal materials and the degree of crushing, micronization can generally save 30 percent to 70 percent of medicinal materials. This is of great significance to the protection of traditional Chinese medicine resources.
The lubricating fingers in the bearing seat of the superfine pulverizer should be replaced regularly, and the temperature rise of the bearing seat should not exceed 35 degree . Do not remove the electrical appliances and belt guards at will. For the personal safety of users, the power supply must be grounded. The pulverized product must be dry, and it is not suitable to process wet and greasy traditional Chinese medicine. The crushed medicine should not exceed half of the capacity of the crushing tank. Generally, it only takes half a minute to crush traditional Chinese medicine, and one minute to crush hard medicine. The machine cannot be used continuously for a long time, and the power-on time should not exceed 5 minutes each time. If the processing quantity is large, it should be used at intervals to prevent the bearing from overheating and damage to the motor. Do not activate the switch while the top cover is open. After long-term use, if the carbon brushes and blades are severely worn, they need to be replaced.
